This project took awhile to complete too, due to careful selection of parts then.
one of my all time favourite liquid cooled rig. Very straight forward, very simple, very clean. It is all done to the customer request like : how u want it sir ? Clean look ? ok noted.
Every of our build always start off with the simplest thing, sleeving !!! Our expertise, our originality in removing the connectors, customizing the tools to remove them. Using the correct sleeving size, right heatshrink importantly. Here is considered the first time on pictures we use this "round rubbery sleeve". It is heat resistant & never go out of shape. Unlike nylon sleeve after prolonged bending & hiding them up.
nothing we cannot remove, remake, repair when a sleeving job go out of control.
this picture shows the sleeve in place but not yet heatshrink up.
we label at the rear for user to identify in future. not the best writing though.
this is very original of our watercooling build. I laughed when someone asked me "will it work" ? isn't the swiftech radbox better & solve the problem ?? He had no idea what case modding is about ... I chose not to reply.
spaced out by 25mm + 25mm ( fan ) + 2mm ( fan dampener )
Silicon gasket maker. It fills up any micro hole between the thread & enhance the O-ring.
Still easy to untighten should I need to replace the fittings or for future servicing. Just peel the " rubber " away.
